You can probably safely drop the verbose parameter altogether. Then I had to install all sorts of things. I tried sudo iwconfig eth1 mode master and I get the following error:. If need, install ethtool from Ubuntu Software Center. You have to use the b43 driver.
|Date Added:||18 October 2013|
|File Size:||20.32 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
hostapd, b43, nl80211 driver, WPA: report, and two questions
Bill August 31, at If hostapv like to contribute content, let us know. Ji m September 25, at 1: After installed the firmware-binstallertry to switch driver from the Additional Driver utility. Click Here to receive this Complete Guide absolutely free. Hostapd problem with b43 nl Soumeet January 18, at 6: Sign up or log in Sign up using Google.
After restarting the system again the old driver is shown when i try to see the driver which is in active. In debug mode, the logs showed that hardware WPA encryption would just die with no explanation. Find out the driver that works for your wireless adapter and support AP mode.
If not, you may consider remove the previous driver wl0 as example: When I try to activate WPA, things hoshapd much worse. As an open access point, it works pretty well. Please suggest some solution which worked for you… Thanks Can you suggest some solution.
hostapd, b43, nl driver, WPA: report, and two questions
BB code is On. Access Point Mode does not support issue is one of the most asked questions from my readers.
April 28th, 4. March 4th, 5. You have to use the b43 driver. So in my case I need to switch wireless driver from histapd to brcmsmac to get AP mode support. My wifi chipset is Broadcom BCM, can the above procedure help in access point mode support?
T May 17, at 2: Ji m November 11, at My b43 driver was giving me hostape for a while and this totally solved them!
Are you new to LinuxQuestions. If yes, uninstall them.
For more details about upgrading I am a new user and dont know about hhostapd. Unable to setup interface. This configuration enables hostapd to start After a good bit of experimentation, I found that disabling QoS support in the b43 driver made things much more stable, by an order of magnitude. I guess the driver might not support AP mode.
Check the below table.