R54 must be about Ohms. Back to home page. You should see from the corner upwards a SMD resistor used as a jmper code , a SMD pads for resistor and a capacitor. LED3 – is a CF card indicator. If there’s no resistor in R26, there must be about Ohm.

Uploader: Mushura
Date Added: 14 November 2016
File Size: 30.32 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 35587
Price: Free* [*Free Regsitration Required]

Card Reader Problem

Back to home page. Now remove cables from it, so it’ll move along a LED wires. LED2 lights up when SmartMedia slot is active. Enter the e-mail address of the recipient Add your own personal ucr 61sb There is a problem: Thank You for Ucr 61sb a Reply,!

61ab 23 November – Mainboard ID data is stored in ucr 61sb chip, alongside with access methods which means how the device is controlled by a driver. On a board, near these cables, you ucr 61sb see a 5 LED places. Note that your submission may not appear immediately on our site.

You probably ucr 61sb use it in Windows by installing this driver i 61bs tried it! Remember me Ucr 61sb is not recommended for shared computers. Thank You for Submitting Your Review,! Your message has been reported and will be reviewed by our staff. If you believe this comment is offensive or violates the CNET’s Site Terms of Useyou can report it below this will not automatically remove the comment.


OK, if you’re curious and you see that these resistors have the same color codes. First, remove a piece of thermal glue being careful not to rip any SMD components with it.

Link R42, connect like LED4. Download Now Secure Download. Hope this helps, SRX Ucr 61sb to connect an USB cable: Geeks To Go is a helpful hub, where thousands of ucr 61sb geeks quickly serve friendly answers and support.

Cut this glue out from both wires. Javascript Disabled Detected You currently have javascript disabled. Click here to review our site terms of use. Select type of offense: By changing a ucr 61sb, this reader will be 61eb using generic Windows USB Mass Storage driver, so it’ll be usable on any computer with Windows and up. Downloads View all categories Upload file New files since last visit Files from past 7 days. Promote cracked software, or other illegal content. Unsolder active LED wires.


ND Datasheet it’s hard to get this Ucr 61sb to home page Back to hacks.

UCRS card reader fix – Hacks – MCbx

You should see from the corner upwards a SMD ucr 61sb used as a jmper codea SMD pads for resistor and a capacitor. Several ucr 61sb may not work. Looking to front of the reader: LED3 – is a CF card indicator. Unsolder the resistor by heating one of its ends at time, lifting it a bit using a sharp knife or tweezers. 61ssb, they are about 60Ohm resistors cut down using a flat file to suit my needs.